4880c一开机就报错00010004的问题

DR37 · 发表于 2009-11-9 17:21:01

同样问题，不过问题还没解决。

侠路相逢A · 发表于 2010-2-4 15:00:02

我也是同样问题，现在还没解决。

侠路相逢A · 发表于 2010-2-4 16:07:33

报00010004 应该是墨头上光检的问题, 我的问题以经解决,光检中间的皮带碰到外面了,光检检测不到东西了,把它放到中间就正常了,由此可判断光检及其连接部分出现问题就可能报00010004 .光检一般不会坏, 脏了或连接不好是比较常见的问题.

liangs1986 · 发表于 2010-2-5 10:52:55

楼主聪明

gzkl · 发表于 2010-11-29 16:18:17

我换了一块主板，马上又坏了，什么原因没有查到，急！

gzkl · 发表于 2010-11-29 16:21:07

直接换了主板，开机ok，打印测试条又坏了。急

image · 发表于 2010-11-29 17:51:45

Service Request errors in the range 00010004 - 000101D are related to a carriage movement problem. In some instances like paper jams, the carriage locking tab may be partially pushed in, causing the carriage locking mechanism to put a drag on the carriage or lock the carriage completely. This will cause a carriage error. Make sure the carriage locking tab is pulled to the left. Then turn the printer’s power off and release the carriage by pushing down on the cutter blade. Slide the carriage to the left and look for any paper that also may be restricting the carriage from moving freely.

00010004 CR Motor encoder check error
00010005 CR Motor out of step
00010006 CR Motor over current
00010007 CR Motor in-position time-out
0001000A CR axis detection error
0001000F CR Motor PWM output faulty
0001001D
CR servo parameter error

The T-Fence may also be dirty or out of the carriage encoder. Check to make sure it is clean and in the center of the encoder. Contact Epson for additional assistance.

gzkl · 发表于 2010-11-30 15:01:40

10004故障在正常情况下是光栅识别问题，其他故障也会引起报错10004；现在是机器完全静默不动情况下报错10004，主板换到好的机器上，也报错10004.

新手之手 · 发表于 2012-3-14 16:23:48

专业维修EPSON大幅面主板，电源板，主板报错的话加QQ674010465 TEL 13213221819

icey100 · 发表于 2012-8-27 15:40:14

不错了，主板换了就郁闷了

		自动登录	找回密码
密码			注册